HCIATTACH

NAME

SYNOPSIS

DESCRIPTION

Hciattach is used to attach a serial UART to the Bluetooth stack as HCI transport interface.  

OPTIONS

-b

Send break.

-n

Don't detach from controlling terminal.

-p

Print the PID when detaching.

-t timeout

Specify an initialization timeout. (Default is 5 seconds.)

-s speed

Specify an initial speed instead of the hardware default.

-l

List all available configurations.

-r

Set the HCI device into raw mode (the kernel and bluetoothd will ignore it).

tty

This specifies the serial device to attach. A leading /dev can be omitted. Examples: /dev/ttyS1 ttyS2

type|id

The type or id of the Bluetooth device that is to be attached, i.e. vendor or other device specific identifier. Currently supported types are

type

description

any

Unspecified HCI_UART interface, no vendor specific options

ericsson

Ericsson based modules

digi

Digianswer based cards

xircom

Xircom PCMCIA cards: Credit Card Adapter and Real Port Adapter

csr

CSR Casira serial adapter or BrainBoxes serial dongle (BL642)

bboxes

BrainBoxes PCMCIA card (BL620)

swave

Silicon Wave kits

bcsp

Serial adapters using CSR chips with BCSP serial protocol

ath3k

Atheros AR300x based serial Bluetooth device

intel

Intel Bluetooth device

Supported IDs are (manufacturer id, product id)

0x0105, 0x080a

Xircom PCMCIA cards: Credit Card Adapter and Real Port Adapter

0x0160, 0x0002

BrainBoxes PCMCIA card (BL620)

speed

The speed specifies the UART speed to use. Baudrates higher than 115.200bps require vendor specific initializations that are not implemented for all types of devices. In general the following speeds are supported:

9600, 19200, 38400, 57600, 115200, 230400, 460800, 921600

Supported vendor devices are automatically initialised to their respective best settings.

flow

If the keyword flow is appended to the list of options then hardware flow control is forced on the serial link ( CRTSCTS ). All above mentioned device types have flow set by default. To force no flow control use noflow instead.

sleep

Enables hardware specific power management feature. If sleep is appended to the list of options then this feature is enabled. To disable this feature use nosleep instead. All above mentioned device types have nosleep set by default.

Note: This option will only be valid for hardware which support hardware specific power management enable option from host.

bdaddr

The bdaddr specifies the Bluetooth Address to use. Some devices (like the STLC2500) do not store the Bluetooth address in hardware memory. Instead it must be uploaded during the initialization process. If this argument is specified, then the address will be used to initialize the device. Otherwise, a default address will be used.

AUTHORS

Manual page by Nils Faerber <nils@kernelconcepts.de>

Index

NAME

SYNOPSIS

DESCRIPTION

OPTIONS

AUTHORS