- -c, --collapse-range
-
Removes a byte range from a file, without leaving a hole.
The byte range to be collapsed starts at
offset
and continues for
length
bytes.
At the completion of the operation,
the contents of the file starting at the location
offset+length
will be appended at the location
offset,
and the file will be
length
bytes smaller.
The option
--keep-size
may not be specified for the collapse-range operation.
Available since Linux 3.15 for ext4 (only for extent-based files) and XFS.
A filesystem may place limitations on the granularity of the operation, in
order to ensure efficient implementation. Typically, offset and len must be a
multiple of the filesystem logical block size, which varies according to the
filesystem type and configuration. If a filesystem has such a requirement,
the operation will fail with the error EINVAL if this requirement is violated.
- -d, --dig-holes
-
Detect and dig holes.
This makes the file sparse in-place, without using extra disk space.
The minimum size of the hole depends on filesystem I/O block size
(usually 4096 bytes).
Also, when using this option,
--keep-size
is implied. If no range is specified by
--offset
and
--length,
then the entire file is analyzed for holes.
You can think of this option as doing a
"cp --sparse"
and then renaming the destination file to the original,
without the need for extra disk space.
See --punch-hole for a list of supported filesystems.
- -i, --insert-range
-
Insert a hole of
length
bytes from
offset,
shifting existing data.
- -l, --length length
-
Specifies the length of the range, in bytes.
- -n, --keep-size
-
Do not modify the apparent length of the file. This may effectively allocate
blocks past EOF, which can be removed with a truncate.
- -o, --offset offset
-
Specifies the beginning offset of the range, in bytes.
- -p, --punch-hole
-
Deallocates space (i.e., creates a hole) in the byte range starting at
offset
and continuing for
length
bytes.
Within the specified range, partial filesystem blocks are zeroed,
and whole filesystem blocks are removed from the file.
After a successful call,
subsequent reads from this range will return zeroes.
This option may not be specified at the same time as the
--zero-range
option.
Also, when using this option,
--keep-size
is implied.
Supported for XFS (since Linux 2.6.38), ext4 (since Linux 3.0),
Btrfs (since Linux 3.7) and tmpfs (since Linux 3.5).
- -v, --verbose
-
Enable verbose mode.
- -x, --posix
-
Enable POSIX operation mode.
In that mode allocation operation always completes,
but it may take longer time when fast allocation is not supported by
the underlying filesystem.
- -z, --zero-range
-
Zeroes space in the byte range starting at
offset
and continuing for
length
bytes.
Within the specified range, blocks are preallocated for the regions
that span the holes in the file.
After a successful call,
subsequent reads from this range will return zeroes.
Zeroing is done within the filesystem preferably by converting the
range into unwritten extents. This approach means that the specified
range will not be physically zeroed out on the device (except for
partial blocks at the either end of the range), and I/O is
(otherwise) required only to update metadata.
Option --keep-size can be specified to prevent file length
modification.
Available since Linux 3.14 for ext4 (only for extent-based files) and XFS.
- -V, --version
-
Display version information and exit.
- -h, --help
-
Display help text and exit.